beautypg.com

Measurement Computing Serial488/4 User Manual

Page 38

background image

Section 1

Introduction

2.26

CMD>OUTPUT09;hello message

send "hello message" out port 1

CMD>ENTER08
1.3A0B009C2D1G0I00000L1N0O00000T010U3

port 3 status is returned since U3 has not changed

CMD>ENTER09
???

port 3 serial data is returned if any has been received

The above examples may also be repeated using Secondary addressing. To do

this, turn off the Serial488/4, set SW1 for Secondary addressing mode. The session
would then appear as presented below.

CMD>

Command prompt from Keyboard Controller program

CMD>OUTPUT0800;S0X

Restore configuration to factory default values

CMD>CLEAR

Reset the Serial488/4

CMD>ENTER0800
1.3C0E0F0G0I000K0M000P0R0Y0Z55880

Status message shows all default options are in use

CMD>OUTPUT0800;P1U1X

select port 1 and port 1 status

CMD>ENTER0800
1.3A0B009C0D1G0I00000L1N0O00000T010U1

Status message shows all default options are in use

CMD>OUTPUT0800;a1b7d0x

Change the configuration of port 1

CMD>ENTER0800
1.3A1B007C0D0G0I00000L1N0O00000T010U1

Status message shows new options are in use

CMD>OUTPUT0800;P3U3X

select port 3 and port 3 status

CMD>ENTER0800
1.3A0B009C0D1G0I00000L1N0O00000T010U3

Status message shows all default options are in use

CMD>OUTPUT0800;C2X

Change parity option for port 3

CMD>OUTPUT0800;C?X

Request current parity option

This manual is related to the following products: