Measurement Computing DaqBoard 3000USB Series - Manual (Page 95)

Note: Specifications are subject to change without notice. 928691 Specifications - DaqBoard/3000USB Series 7-1
Specifications –
DaqBoard/3000USB Series
7
I/O Comparison Matrix
Model
DaqBoard/
Analog Input
Channels (ADC)
Analog Output
Channels (DAC)
Digital I/O
Channels
Counter
Inputs
Timer
Outputs
3001USB 16SE / 8DE 4 24 4 2
3005USB 16SE / 8DE 0 24 4 2
3031USB 64SE / 32DE 4 24 4 2
3035USB 64SE / 32DE 0 24 4 2
General Specifications
Power Consumption (per board):
Model Power Consumption (Typical)*
* An optional power adapter (TR-2) will be required if the
USB port cannot supply adequate power. USB2 ports
are, by USB2 standards, required to supply 2500 mW
(nominal at 5V, 500 mA). /3001USB 3000 mW
/3005USB 2000 mW
/3031USB 3400 mW
/3035USB 2400 mW
Power Output for DaqBoard/3000 USB
Output Power
Supply Voltage
Tolerance Pin Numbers
Power Allowed when
using USB Power
Power Allowed when
using External Power
+5 V ± 20% P5-19; J7-22; J8-25 2 mA 10 mA
+13 V ± 10% J8-1 1 mA 5 mA
- 13 V ± 10% J8-2 1 mA 5 mA
Environment:
Operating Temperature: -30 to +70°C; Storage Temperature: -40 to +80°C
Relative Humidity: 0 to 95% non-condensing
Communications Speed: USB 2.0 high-speed mode (480 Mbps) if available,
otherwise, USB1.1 full-speed mode (12 Mbps)
Acquisition Data Buffer: 1 MSample
Vibration: MIL STD 810E Category 1 and 10
Signal I/O Connectors: ( see chapter 2 for pinouts )
68-pin standard “SCSI type III” female connector (P5); Four 40-pin headers (J5, J6, J7, J8),
AMP# 2-103328-0
Option TB-100: An optional TB-100 terminal board can be connected to the 3000USB board’s 68-
pin SCSI connector via a CA-G55, CA-56, or CA-56-6 cable. The TB-100 provides access to
16SE/8DE analog inputs, up to 4 analog outputs, 24 digital I/O, and all counter/timers. When
using TB-100 with 3035 or 3031 models the remaining 48SE/24DE are accessed through 40-pin
headers (
see chapter 2 for details ).
Option TB-101: An optional TB-101 screw terminal board can be mounted directly to a 3000USB
Series board, providing screw terminal connections for all of the board’s I/O (
see chapter 2 for
details ).
Temperature Measurement Connector: ( see chapter 2 for pinouts )
4-channel TC screw-terminal block (TB7); Phoenix # MPT 0.5/9-2.54
External Power:
Connector: Switchcraft#RAPC-712
Power Range: 6 to 16 VDC (used when USB port supplies insufficient power,
or when an independent power supply is desired)
Over-Voltage: 20 V for 10 seconds, max.