Legrand 364725-xx - Manual (Page 2)

D. Terminating the Outlet Cables
1) Route the cable to the RJ45 Jack or 110 punchdown block on the module.
2) Trim the cable to allow at least three (3) inches of excess cable.
3) Terminate the cables as outlined above.
4) Insert RJ45 Plugs into appropriate jacks (if applicable).
E. Terminate and Connect Video Cables (refer to Figure 3).
1) Locate video source cable (CATV or antenna) position to attach to the input of the splitter.
2) Cut the cable approximately two (2) inches beyond the splitter, allowing slack for cable
management. Use a high quality cable cutter to avoid distortion of the cable and center
conductor. If cable marking is cut off, re-mark in an area that will be visible after installation.
3) Strip and prep per connector instructions. Use a coax stripper to ensure clean cuts without
damaging the center conductor.
4) Install high quality “F” style connectors. Use proper insertion and crimp tools.
5) Attach securely to the proper port of the splitter.
6) Repeat for outlet cables.
F. Securing Cables
After all cables are connected to the module, the cables should be bundled and grouped to allow ease
of maintenance. Wire management straps (P/N 363491-01), may be used to bundle cable.
G. Making a Power Cable Jumper
1) The “video” portion of this combo module is powered by a typical power cube that plugs into the
AC outlet at the bottom of the enclosure.
2 ) The actual power cable that goes between the power cube and the video module must be con-
structed by terminating an appropriate length of RG-6 (solid copper) with male “F” connectors.
3) Once terminated, screw one “F” connector onto the video module’s “power in” jack, and screw
the other end of the power cable onto the “F” connector jack on the power cube.
4. Other Applications (If Applicable)
A. Security Interface (refer to Figure 4 for Pin Out)
1)
To enable line seizure and dial out capability to most security systems,
connect the RJ31X cable (supplied with the security system) to the RJ45
“Security” jack on the module. TURN OFF SW1 to activate security link.
Connect the other end to the security system as outlined in the security
system installation instructions.
2) To disable security, remove plug from “security” jack and set SW1 to
“ON”.
OnQ Technologies, Inc.
P.O. Box 60907
Harrisburg, PA 17106-0907
800-321-2343
www.onqtech.com
Installation/Instruction Sheet
OnQ Amplified Combo Module
IS-0266 Rev. O
IS-0266 Rev. O Page 2 of 2
Figure 4