Legrand 363293-01 - Manual (Page 2)

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 2 of 2
INSTRUCTION/INSTALLATION SHEET
110 PUNCH DOWN TOOL, IMPACT STYLE
IS-0282 REV. A
©Copyright 2008 by On-Q/Legrand All Rights Reserved .
3. INSERTING/REMOVING BIT
To insert bit:
A. Push and turn the bit into the bit holder until it slides into place.
B. Rotate the bit 90
° clockwise until it locks into place.
To remove bit:
C. Reverse the previous steps.
4. BIT STORAGE
To insert bit into bit storage:
A. Hold the impact tool with the bit storage end facing up.
B. Insert the bit into the bit storage end as far as it will go.
C. Turn the release dial in a clockwise direction until the bit slides into place.
To remove bit from bit storage:
D. Hold the impact tool with the bit storage end facing down.
E. Turn the release dial in a counter clockwise direction until the bit falls out.
5. OPERATING INSTRUCTIONS
Style 110 Terminating Blocks:
A. Lay the wires in the wire slots.
B. Insert the 110 terminating bit into the impact tool and choose the correct end of the bit depending whether or not
the wire is to be cut off. (Illustrations show use of the cutting end)
C. Slide the bit into the wire slots and push down on the impact tool with the palm of your hand until it clicks.
D. Slide the bit out of the wire slots and make sure the wire is properly seated on the bottom of the wire slots. The
impact tool should ensure this is done right, but it is always a good idea to check.
Wire Slots
Terminated
and Trimmed
Cutting Edge