Legrand 363293-01 - Manual

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 2
INSTRUCTION/INSTALLATION SHEET
110 PUNCH DOWN TOOL, IMPACT STYLE
IS-0282 REV. A
©Copyright 2008 by On-Q/Legrand All Rights Reserved .
110 Bit
Cutting Edge
Bit Holder
Bit Storage
Impact Indicator
Release Dial
Impact Adjustment
1. Introduction
P/N: 363293-01
110 Punch Down Tool, Impact Style
The impact tool is a spring-loaded tool used to terminate twisted pair cable on style 110 terminating blocks. The
spring-loaded mechanism assists in assuring the wire is properly seated on the contact. There is an impact
adjustment dial which can be turned from hi to low depending on application. Included with the tool is a 110
terminating bit. The bit has a terminating end and a terminating cut end. This gives the option to terminate and
connect a wire to series of contacts or just terminate and cut the wire to an individual contact.
2. ADJUSTING IMPACT SETTING
A. Turn impact adjustment dial so the arrow is pointing at the hi or low setting.