Legrand DA1002 User Manual

Is-0394 rev. o

INSTRUCTION / INSTALLATION SHEET
5-Port Fast Ethernet Switch

IS-0394 Rev. O

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com

Page 1 of 2

Figure 1

Figure 2

INTRODUCTION

The On-Q/Legrand 5-Port Fast Ethernet Switch (P/N DA1002)
supports up to five computer connections in an Ethernet local
area network at a throughput of up to 200 Mbps, and acts as a
high-speed Cat 5e termination point for digital data services (see
Figure 1).

DESCRIPTION

The On-Q/Legrand 5 Port Fast Ethernet Switch improves
computer performance by providing dedicated bandwidth to
every user, and offers the following benefits:

• Includes single bay bracket (P/N 364890-01) for mounting

in On-Q style enclosure (see Figure 2)

• Automatically adjusts each port to the highest speed

available; No configuration/service interruptions when
migrating from 10Mbps to 100Mbps

NOTE: The LED on the left below each RJ45 jack will light
to indicate 100Mbps operation. The LED on the right
below each RJ45 indicates a valid Ethernet link and/or
data activity (see Figure 1).
• Multiple switches can be cascaded together using a

standard Cat 5 patch cable

POWER REQUIREMENTS

The 5-Port Fast Ethernet Switch's power requirements are:

• Voltage: +12 VDC
• Current: 300 mA
• Power:

4 W Max

• Polarity: Tip (+) Barrel (-)

Note: On-Q/Legrand offers several options for power, which range from a dedicated power cube (F7760)
designed to accommodate one module to power solutions designed to accommodate multiple module
installations.

Please refer to the On-Q/Legrand Catalog or the On-Q/Legrand website (http://www.onqlegrand.com)
for more information.

INSTALLATION

A. MOUNT THE SWITCH ONTO THE ENCLOSURE.

1. Pull out the plungers which are located at each corner of the 5-Port Fast Ethernet Switch

2. Insert the module onto the included single bay bracket and depress each of the four plungers to secure

the module to the bracket

3. To mount the bracket with module into the enclosure, insert the tabs on the left side of the bracket into

the slots in the enclosure and push the bracket pushpin into the appropriate hole in the enclosure to
secure the bracket (with module) to the enclosure