Legrand 863 Series Outlet Boxes - Manual

863 Series Outlet Boxes
For Wood Floors
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 006 111 – February 2007
Wiremold / Legrand electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold / Legrand electrical
products may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
Products Covered: 863DRGFICOM, 863DRGFICOMAL, 863DPCOM, & 863DPCOMAL
Applications: This unit is for wood floors with: sunbflooring with carpet and padding, or subflooring with hardwood or linoleum floor covering
Ground Wire
OUTLET BOX INSTALLATION:
1. Determine the floor box location. (Make sure the
placement does not interfere with obstructions below
such as floor joists, HVAC duct, light fixtures, etc.).
Drill a hole through the flooring with either a 4 3/8" or
4 1/2" [111mm - 114mm] hole saw.
2. Pull the nonmetallic sheathed cable approximately
12" [305mm] up and through the hole.
3. Pull the nonmetallic sheathed cable into the box using
the knockout or strain relief feature.
4. Remove any plaster ears from the receptacle before
wiring and attaching the receptacle to the box.
Note: The ground wire in the box, the sheathed cable,
and a pigtail from the receptacle all need to be
connected to properly ground this box and cover.