Legrand MRH5 - Manual (Page 3)

SET HOUSE ID
All Miro wireless devices installed in the same home must acquire the same
unique House ID before use. This process is known as house binding. Each
Miro wireless device is bound to all other Miro wireless devices in the house.
New Installation
1. With all devices installed and energized, make sure that every Miro wireless
device LED is yellow. If any LED is off, be sure the circuit breaker is on and
the device is correctly installed.
The MRH5 remote shuts down
when it is not in use. Press any
button to activate the remote and
illuminate its LED.
2. Press on any device paddle until
the LED flashes yellow (about 2
seconds). This indicates that it has
acquired a unique House ID.
3. Make sure that all other Miro wireless device LEDs are flashing green,
indicating that they have acquired the same House ID. For MRH5 or MRH6
remotes, be sure that the units are awake during the binding process. Press
any button to activate the remote and illuminate its LED.
4. Return to the device used in step 2, which is still flashing yellow. Press
until the LED changes to solid green (about 2 seconds). All device LEDs in
the House change to solid green, indicating house binding is complete.
Adding a Device to an Existing Installation
If you’re adding or replacing a device in a Miro wireless installation that is
already operating, the new device must be bound to the same House ID as the
other Miro wireless devices in the house. After the new device is powered up,
the LED should be solid yellow. This indicates that it has not yet acquired a
House ID. To acquire the House ID for the existing system:
1. Press on any previously bound device until the LED flashes yellow (about
2 seconds).
2. Verify that the newly added device LED is flashing green, indicating that
it has acquired the House ID. In the case of the MRH5 or MRH6 handheld
remotes, be sure that the unit is awake during the binding process. Press
any button to activate the remote and illuminate its LED.
3. Return to the same previously bound device used in step 1 and press until
the LED changes to solid green (about 2 seconds). All device LEDs should
now be solid green.
When you see
in the instructions,
firmly press and
hold both the top and
bottom of the paddle
until the LED changes
(about 2 seconds).