Legrand AU5010-XX - Manual (Page 5)

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 5 of 8
INSTRUCTION/INSTALLATION SHEET
lyriQ™ Studio High Performance
Keypad
IS-0425 REV. A
©Copyright 2009 by On-Q/Legrand All Rights Reserved.
4. Operation
A. ON/OFF:
Keypad – Press STANDBY button to toggle ON or OFF (see
Figure 5).
Remote – After pressing On-Q button, press On/Off button to
toggle ON or OFF (see Figure 6).
B. Power-Save
Mode:
Keypad only – After 30 seconds of inactivity, the Keypad will go
into Power-Save or “sleep” mode. Pressing any button on the
Keypad will awaken it from this mode, performing the action
associated with the button push.
C. SOURCE select:
Keypad – Press SOURCE rocker switch up (right side) or down
(left side) to select desired source (see Figure 5).
Remote – Press SOURCE UP or DOWN button to select desired
source (see Figure 6).
NOTE: (Keypad or Remote) For Single Source Systems, source
toggles between source #1 and any connected Studio Local
Source/s. For Multi-Source Systems, source toggles between 1,
2, 3, 4 and connected Studio Local Sources. If more than one
Local Source is connected, they are indicated by “L” and “2”.
NOTE: Upon source change, volume mutes and then ramps
back up to prior volume setting automatically.
D. VOLUME Steps: Keypad or Remote – Press VOLUME + (Up) or VOLUME –
(Down) button (36 steps).
E. MUTE: Keypad or Remote – Press MUTE button to toggle Mute On or Off.
NOTE: When returning from MUTE, volume control will ramp to pre-
mute or adjusted state (source, volume and backlight level).
F. DO NOT DISTURB (see Figure 5):
When the Keypad is off, pressing MUTE toggles Do Not Disturb (DND).
This mode is indicated by both the red POWER and MUTE LED on.
When Keypad is in DND mode, it will Not respond to whole house
commands from other locations.
G. WHOLE-HOUSE Mode (see Figure 5):
NOTE: In this mode, every operation performed on this keypad will be
relayed to all keypads not in (DND) mode in the system.
Keypad or Remote – Press the WHOLE HOUSE button to toggle the
Whole House function On or Off (On the Keypad, the WHOLE HOUSE
Figure 5
Source
LEDs
Source
Button
Mute
Button
Volume
Buttons/
LEDs
IR
Target
Standby
Button
Whole
House
Button
Figure 6
On-Q
Button
Source
Buttons
Volume
Buttons
Mute
Button
Whole
House
Button
Room
Button
Local
Button
i Button
On/Off
Button
On-Q Universal
Remote
(P/N AU1060)