Legrand DS4000 Mounting Bracket - Manual

DS4000 ™ Mounting Bracket
& Splice Cover
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 43269 – July 2006
Wiremold / Legrand Electrical Systems conform to and should be
installed and properly grounded in compliance with requirements
of the current National Electrical Code, Canadian Electrical
Code, or codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.
j
Step 1. Position the DS4003 Mounting Bracket in the
middle of location where a section of
ALDS4000B or DS4000B Raceway Base is to
be mounted. Secure to mounting surface with
minimum #8 flat head screws.
Step 3. Secure the ends of the raceway base section to the mounting surface
with minimum #8 screws.
Step 2. Hook raceway base onto bottom of DS4003 Mounting
Bracket and snap into place.
Products Covered: DS4003, DS4006A
For more information, visit www.wiremold.com/ds4000.
DS4003
Mounting Bracket
Minimum #8
Mounting Screws
DS4003 MOUNTING BRACKET INSTALLATION: