Legrand Wallduct Medical Raceway System Bodies - Manual (Page 2)

Step 1 Bodies need to be butted together using
coupling angles provided and #10-32 "taptite"
screws. All screws are required for proper
electrical bonding between bodies and
attachment to wall.
Step 2 With bodies connected and mounted to wall
with screws, place partitions into duct as
necessary making sure wire fill requirements
are followed as per NEC (Wire fill information
is also located onlast page of instruction sheet).
Step 3 Place wires into duct and then slide wire
retainers into place (wires not shown for
clarity). The wire retainer fits in slots located
at the end of each duct body and in the
middle of a 60" [1,524mm] body.
Step 4 To attach cover, place palnut clip over holes
on top side of duct as shown. Position cover
and secure into place using #10-32 machine
screws provided.
Palnut Clip
SPECIFIC INSTRUCTIONS: STRAIGHT BODIES AND THEIR COMPONENTS
Follow the instructions on page 1 for surface mounting application. Bodies are supplied from factory with wire
retainers, coupling angles, and necessary fasteners. Fasteners to mount bodies to wall are supplied by installer.
Access cover plates not shown here are installed similar as described for cover plates shown below. Apply
supplied grommet to access cover plates.