Legrand ALDS4000 Designer Series Large Raceway - Manual

DS4000/ALDS4000
Prewired Raceway
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 43619 – July 2006
Wiremold / Legrand Electrical Systems conform to and should be
installed and properly grounded in compliance with requirements
of the current National Electrical Code, Canadian Electrical
Code, or codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.
j
For more information, visit www.wiremold.com/ds4000.
Step 1. If the installation requires Fittings,
start at an appropriate location
such as a corner. Refer to specific
fitting installation instructions for
proper mounting.
Step 2. Leaving Couplings loose, slide
DS4000 Base section onto
installed Adjust-to-Fit
™
Couplings until Base Section
butts against Fitting. Tighten
Coupling Screws. Secure Base
Section to the wall using #8
Fasteners spaced 48"
[1.2m] apart
Note: ALDS4000 Base is not
provided with mounting
holes. Drill a hole at
desired mounting location
or use self-drilling screws.
Step 3. Butt succeeding DS4000 Base Sections
tightly to installed base in order to
maintain hole alignment. Slide Couplings
into place and tighten.
Adjust-to-Fit™
Couplings
Note: Wires have been removed for clarity.
Note: Wires have been removed for clarity.
Step 4. Raceway can be fed using several methods.
1. Use DS40410A/ALDS4010A Entrance End Fitting. (See specific installation instructions.)
2. Use DS4010B Blank End Fitting. (See specific installation instructions.)
3. Drill a hole into Base Section for 1/2", 3/4", or 1" trade size conduit.