Legrand ALDS4000 Designer Series Large Raceway Elbow Fittings - Manual

ALDS4000 Elbow Fittings
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 43372R1 – Updated April 2006
Wiremold / Legrand Electrical Systems conform to and should be
installed and properly grounded in compliance with requirements
of the current National Electrical Code, Canadian Electrical
Code, or codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.
j
Step 1. Drill mounting hole into the base. Line the hole up
with the screw clearance groove in a coupling.
Step 2. Mount fitting to wall with #8 screws. (Not provided)
Install couplings as shown.
Step 4. Snap on fitting covers as shown. Step 3. Install raceway base. Refer to Raceway base
installation instructions for proper mounting.
Step 5. Install raceway covers to complete installation.
Products Covered: ALDS4011, ALDS4015, ALDS4017, ALDS4018, ALDS4010A & ALDS4010B
For more information, visit www.wiremold.com/ds4000.
TO MOUNT ALDS4011, ALDS4015, ALDS4017, ALDS4018: