Figure 3 – Legrand WKD ProSeries Underfloor Duct Trim Flange User Manual

Page 2

The Wiremold Company
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
850 Gartshore Street • Fergus, Ontario N1M 2W8
1-800-741-7957 • FAX 519-843-5980

1 002 598 0702

S125-837PCC Assembly with 828PR and 829PSTC:

Step 4. Important: Tighten bonding screw in base of preset.

Step 5. Using hardware bag 97650A secure link straps

to posts in preset. Position straps in outer presets

A. Pull wires to preset and leave slack.

for three-gang flange. None are used in center

B. Use Cat. No. 427 Fiber Optic Loop Kit

preset. Install two flathead screws in opposite

if fiber optic cable is being installed.

corners to attach flange to link straps. Two lengths
of screws are provided to accommodate variations
in concrete pour depth (see Figure 3).

Step 6. Make splices in preset and pull wire through connector

to final termination.
A. Wire UL Listed device or power/communication

devices and attach to trim flange.

B. Attach cover plates and complete installation

as shown.

C. For tile floors, apply a bead of caulking along

bottom perimeter of trim flange.

Double Duplex Cover,
Membrane and
Receptacles Included
with Assembly – Orient
receptacles with Neutral
Sides Facing Each Other

829PSTC Communication
Cover, or Other As Required

Pro Series Preset or Afterset Insert

Link Strap (Four Required)

828PR Duplex Cover,
or Other As Required

Figure 3