beautypg.com

Legrand WKD ProSeries Underfloor Duct Trim Flange User Manual

Service fitting, Polycarbonate trim flanges, Installation instructions

background image

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.

Products Covered: S125-837PCC

®

Walkerduct Pro Series Presets:

Step 1. Use a Walker insert finder (Cat. No. 480) or other

Step 2. Remove mudcap: (See Figure 1):

electronic locator to find center of preset. Cut and

A. Strike blade of screwdriver or 1/4" [6.4mm]

remove carpeting or tile over preset. (Carpet may

cold chisel along side of mudcap as shown.

be saved for abandoning.) Chip out concrete to

Top edge of mudcap will deflect inward.

expose mudcap.

B. Pry out cap with screwdriver by positioning

blade between preset wall and deflected
edge of mudcap, or, use pliers to grab
edge of cap and lift out.

C. Grout around opening if concrete

does not break away cleanly.

Step 3. Remove knockout: (See Figure 2):

A. Insert screwdriver blade into opening in

base of preset. Push screwdriver toward
center of preset, breaking tabs. Position
screwdriver into opening on other side
of knockout and break tabs to
release knockout.

B. Inserting a wire hook into arched opening

at center of preset will prevent knockout
from falling into duct. Remove all debris
from raceway.

CAUTION: Some sharp edges may occur along

knockout tabs. These must be deburred.

S125-837PCC

Service Fitting

Polycarbonate Trim Flanges

INSTALLATION INSTRUCTIONS

Walker

®

electrical systems conform to and should be

properly grounded in compliance with requirements
of the current National Code or codes administered
by local authorities.

All electrical products may present a possible shock or
fire hazard if improperly installed or used. Walker elec-
trical products may bear the mark as UL Listed and/or
Classified and should be installed in conformance with
current local and/or the National Electrical Code.

Important:

The duplex receptacles used in the
center gang of this assembly must be
Pass & Seymour BR15, 5252, IG6200,
or Leviton 5262. The double duplex
cover with membrane can only be
installed in the center gang.

NOTE: If presets are more than 1" [25mm] below concrete,

use of a hammer drill with 1/2" chisel is recommended.
Be careful not to damage preset.

Figure 1

Strike Downward
Near Edge

Figure 2