Legrand NM2000 Series Nonmetallic Plugmold Multioutlet System - Manual (Page 2)

Connect receptacle harness to feedpoint
using approved methods. B1
Wired Cover Sections: B
Snap cover/harness assembly onto
base and snap on any fitting covers. B2
To remove, back out screw
and unplug. To replace, push
in plug and install screw. C1
Wired Cover Sections with Receptacle
Surge Protection – NM20SGB Series:
Install wired cover system as above.
C For additional circuits, use bypass area shown below. B3
Lay out Snapicoil harness so that receptacles are
not located over feed point or at corners. Connect
harness to feed point. D1
Snapicoil – NM2000SC Series: D
Snap receptacles into
NM2000 cover. D2 Snap wired cover section
onto base and snap on
any fitting covers. D3
Install mounting clip using
flat head screws. E1
Relocatable Power Tap – NM20C: E
Snap unit into
mounting clips. E2
Plug cordset into wall outlet. E3
Bypass
Areas
End View
NM2027SP
NM2003
The Wiremold Company
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6251
Canada:
850 Gartshore Street • Fergus, Ontario N1M 2W8
1-800-741-7957 • FAX 519-843-5980
41080R4 – Updated June 2003
© Copyright 2003 The Wiremold Company All Rights Reserved
NOTE: This device features an internal protection that will disconnect
the surge protective component at the end of its life but will
maintain power to the load – now unprotected. If this situation
is undesirable for the application, follow manufacturer’s
instructions for replacing this device.