Legrand 6B21E - Manual (Page 4)

Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
BK007R1 – Updated March 2007 – For latest specs visit www.wiremold.com
© Copyright 2007 Wiremold / Legrand All Rights Reserved
CAUTION: The three-prong, grounding type plugs in all units are for use with 3-prong, grounded receptacles only. Modifying
or bypassing the ground pin for use in a non-grounded receptacle may lead to electrical shock, is not recommended and
voids the product warranty. All units are designed for interior use in dry locations only. Check all local and national electrical
codes for proper installation.
ABOUT YOUR WIREMOLD PRODUCT: Each unit is 100% tested prior to packaging. Power Commander ® products are
specifically made for use in the IT environment. These units are rated for 30 amps, 120 volts, 60 Hz or 40 amps, 208 volts,
60Hz. Consult product label for details.
TROUBLESHOOTING: If you are receiving no power to your Wiremold product, first make sure the unit is plugged firmly into
your wall outlet. Plug the unit into a different wall outlet to verify the condition. If there is still no power, the built-in circuit
breaker may need to be reset. If you are still having problems, please call technical support.
Understanding that each cabinet, enclosure, rack and application is unique, Wiremold has designed
four solutions for mounting the 30 Amp Power Distribution Units using the universal T-slot built into the
unit. The mounting kits listed below are available for purchase as accessories.
Catalog No. 30A-MK1 – Z Bracket
Sturdy anodized aluminum bracket
offsets the unit for front access to the
mounting. May be used for a side or
end mount.
Catalog No. 30A-MK2 – L Bracket
Allows mounting at a right angle. May
be used for a side or end mount.
Catalog No. 30A-MK3 – Swivel Bracket
Allows unit to be mounted then rotated up
to 270° (dependent on mounting location)
providing easy access to unit’s face
without losing space.
Catalog No. 30A-MK4 – Drop-In Clip
Clip is mounted directly on the unit and
allows the strip to install with a “drop
and hold” method that requires no
additional hardware.
NOTE: Accessory mounting kits are not UL Listed.
MOUNTING ACCESSORIES