Legrand RC9 Poke-Thru Series - Manual (Page 2)

2
Slide Cover Mounting
Screws Two #6-32
Outlet Box
Cover Plate Screw
Step 6 Cat. No. RC9A15TC
Wire the Poke-Thru device (Can be completed
above floor). Refer to wiring schematic in Step 8.
Step 8 Connect Poke-Thru conductors according
to required device configuration. See
schematic below.
Step 7 Wire the POWER circuit.
WARNING: Ground wire from junction box must
be connected to SYSTEM GROUND.
CAUTION: Receptacle mounting means not grounded.
Grounding wire connection required. For isolated
ground wiring, connect ground leads to a separate
isolated grounding conductor. See NEC 250-146(d).
NOTE: The orange triangle shall only be placed on devices that
are wired for isolated ground. See NEC 250-146(d).
NOTE: When installing Cat No. RC9CTC to existing stems, apply
wiring label to the inside of the junction box cover.
COMPLETE ASSEMBLY
Step 9 If circuit is connected to an isolated ground,
apply IG icon on receptacle slide as shown.
SLIDE HOLDER ASSEMBLY