Legrand RC4KTCBK - Manual (Page 2)

COMPLETE ASSEMBLY:
Step 6. Cat. Nos. RC4ATC or RC4ARTTC. Step 7. Wire the power circuit. See wiring diagram.
Wire the Poke-Thru device.
(Can be completed above floor.)
Refer to wiring schematic in Step 8.
Step 8. Wiring Diagram. Connect receptacle Step 9. If circuit is connected to an isolated ground
leads to branch circuit conductors apply IG icon on receptacle slide as shown.
as required.
WARNING: Ground wire from junction box must be connected
to SYSTEM GROUND.
CAUTION: Receptacle mounting means not grounded. NOTE: The orange triangle shall only be placed on devices
Grounding wire connection required. For isolated that are wired for isolated ground. See NEC 250-146(d).
ground wiring; connect ground leads to a separate
isolated grounding conductor. See NEC 250-146(d).
2
Two #6-32 Slide Cover
Mounting Screws
NOTE: Gasket and gasket
support must be
removed before wiring
data connections.
Gasket
Gasket Support
Branch Circuit Conductors
Electrical and Communication Cables May be
Connected to Unit Prior to or After Activation.
Junction Box
24.5 cu. in. [400cm
3 ]
Circuit “B”
Circuit “A”
Circuit “A” Circuit “B”
Line Black Red
Neutral White White w/Blue Stripe
Ground Green Green w/Yellow Stripe
Electrical Wiring Chart