Legrand 6ATC 8 - Manual (Page 3)

3
Step 4 Push Poke-Thru into floor.
Step 3 Place appropriate gasket around
poke thru and slide under flange.
Use flat foam gasket for surface
tile applications or use round
neoprene gasket for carpet
applications. For the flush tile
applications no gasket is needed. Step 2 If circuit is connected to an isolated
ground, apply IG icon on receptacle
plate as shown.
Step 5 Installation complete.
For Carpet or Surface Mounted Tile Installation
For Flush Tile Installation (Start with Steps 1 & 2 on previous page.)
Step 3 Place shims around bottom of flange to
match thickness of tile. Flange is 1/8"
thick. (2) 1/8" shims and (2) 1/16" shims
are provided. Push Poke-Thru into floor. Step 4 Use grout and/or silicone caulk
between edges of flange and tile.
NOTE: If more shims are required, use Cat. No 8TS.
NOTE: The orange triangle shall only be placed
on devices that are wired for isolated
ground. See NEC 250-146(d).