Legrand AL2040A Aluminum Surface Raceway User Manual
Page 3
AL2410B BLANK END FITTING
AL2410B2 FEED END FITTING
AL2440A IN-LINE SINGLE POLE SWITCH
At end of AL2400B Raceway run, slide AL2410B2 Feed End
in last base section. Secure in place by tightening two #8-32
set screws. This system is designed with capacity for
additional feed or circuitry conductors.
At end of AL2400B raceway run, slide AL2410B Blank End
Fitting in last base section. Secure in place by tightening
two #8-32 screws.
Single Pole Switch 15A. 120V. To Install slide coupler into
groove of AL2400B raceway base and push base section
together. Tighten screws, connect all wires and snap in
cover to complete installation.