Legrand AL2040A Aluminum Surface Raceway User Manual
Page 2
AL2400B BASE and AL2400C COVER
AL2401 COUPLING
AL2409 GROUND ADAPTER
AL2451H BOX ADAPTER
At AL2400B base section butt joints, slide AL2401 Coupling
into flathead first base section than slide next base to surface.
Center coupling on joint. Tighten locking screws.
To attach AL2400B base section to mounting surface, drill 9/32"
holes in the base (approx. 48" o/c.) fasten base with #8 head
screws. Snap AL2400C cover to complete installation.
Use for feed raceway from existing wall outlet box. To install,
attach adapter to outlet box with two screws. This system
is designed with capacity for additional feed or
circuitry conductors.
Position AL2409 Ground Clamp into rib in AL2400 raceway
base. Tighten locking screw. attach ground wire using
brass cup washer and green hex nut to ground lug.
AL2406 COVER CLIP
AL2400P-D SERIES
To close any gaps at either the base or the cover that occur
from field cutting, Snap AL2406 Cover Clip over the joints
on the assembled raceway.
For AL2400P-D series duplex plates, Install wiring to devices
as required. Attach device to plate using #6 screws and
"Kep"nut (Provided) Snap device plate onto AL2400B
raceway base.
AL2400B
48" O.C. MAX
AL2400C