Legrand AL2000 Small Aluminum Surface Raceway - Manual (Page 4)

AL2015 TEE ELBOW AL2018 EXTERNAL ELBOW
AL2015 Tee Fitting, position fitting at end of AL2000B base.
Install other base section to other end of fitting. Center
couplings on joints and tighten screws. Install fitting
cover after wiring. At 90° outside corner, position AL2018 External Elbow at end
of joints and tighten screws. Install fitting cover after wiring.
The Wiremold Company
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-421-6196 • FAX 860-232-2062 • Outside U.S. 860-233-6251
INST020 R1 – Updated September 2003 – For latest specs visit www.wiremold.com © Copyright 2003 The Wiremold Company All Rights Reserved
AL2416 CROSS ELBOW
AL2416 Cross Elbow, position fitting at end of AL2000B base.
Install other base sections to other ends of the fitting.
Center couplings on joints tighten screws. Install
cover fitting after wiring.
AL2000B BASE
To attach AL2000B base sections to mounting surface, drill
9/32" holes in the base (approx. 48" o.c.). Fasten base with
#8 flathead head screws.
AL2000WC WIRE CLIP
For retaining wires in long raceway run, Snap-in AL2000 WC
Wire Clip approximately 30" apart into AL2000B base.
AL2001 COUPLING
At AL2000B base section butt joints, slide AL2001 Coupling
into first base section mount next base to surface. Center
coupling on joints. Tighten locking screws.
AL2009 GROUND CLAMP
Position AL 2009 Ground Clamp into rib in AL2000B raceway
base. Tighten locking screw. Attach ground wire using brass
cup washer and green hex nut to ground lug.
AL2051H BOX ADAPTOR
Use for feed raceway from existing wall outlet box. To install,
attach adapter to outlet box with two screws. This system is
designed with capacity for additional feed or circuitry conductors.
48"
[1219mm]