Legrand AL2000 Small Aluminum Surface Raceway - Manual (Page 3)

AL2010A FEED END FITTING
AL2010B BLANK END FITTING Al2043 IN-LINE RECEPTACLE
AL2043IG IN-LINE ISOLATED
GROUND RECEPTACLE AL2040A IN-LINE SINGLE POLE SWITCH
For AL2043 Series Two 15A, 120V U-ground factory prewired
receptacles. To install slide coupler into grooves of AL2000B
end base raceway and push sections together. Connect
wires, tighten. Screws and snap in cover. At end of AL2000B base raceway run, slide AL2000A or
AL2000B fitting in last base section. Secure in place by
tightening screw.
For AL2043IG Series Two 15A, 120V Isolated ground factory
prewired receptacles. To install slide coupler into grooves
of AL2000B base raceway and push sections together.
Connect wires, tighten screws and snap in cover. Single Pole Switch 15A. 120V. To Install slide coupler into
groove of AL2400B base raceway and push sections together.
Tighten screws and snap in cover.
AL2038 SERIES ROUND
FIXTURE BOX AL2044 SERIES DEEP
DEVICE BOX AL2047 SERIES SHALLOW SWITCH
AND RECEPTACLE BOX
TO INSTALL
1. Attach back plate to 2x4 outlet utility box or mounting surface.
2. If back plate is not attached to box, use cover to close opening.
3. 1/2" or 3/4" conduit connections may be connected to back cover.
4. Slide AL2000B base raceway into slot of back plate. Tighten set
screws to secure connections and for ground continuity.
AL2011 90° FLAT ELBOW AL2017 INTERNAL ELBOW
At 90° turn on same surface, position AL2011 Flat Elbow at end
of AL200B base. Position next base section onto other end of
AL2011. Center coupling over base joints and over base joints
and tighten screws. Install fitting cover after wiring. Install AL2017 to raceway base BEFORE mounting raceway
base. Fasten section to surface joints, tighten set screws.
Center coupling over base and tighten screws. Install
fitting cover after wiring.
5. Twist out KOs in cover section where raceway enters.
Attach cover with screws.
6. Attach device ( if required) to cover section.
7. Install standard cover plate.