Sealing the dies – Ivoclar Vivadent Vectris User Manual
Page 53
53
3-
UNIT
INLA
Y
-
RET
AINED
BRIDGES
Sealing the dies
After having removed the matrix and cleaned the duplicate
model, apply Vectris Model Separator in two coats. Apply
the first layer slightly more generously than the second one
and make sure to fully cover all areas of the die. Watch out
for sharp edges in particular. Allow the first layer to react
for 3 minutes. Subsequently, apply the second layer of
Vectris Model Separator in a thin coating, invert the model
and allow it to dry for another 3 minutes.
Apply a generous coat of Vectris Model Separator and allow it to dry for approx. 3 minutes.
Apply the second layer of Vectris Model Separator in a thin coating and allow it to dry for
another 3 minutes upside down.
See also other documents in the category Ivoclar Vivadent Equipment:
- 14K (2 pages)
- 24K (2 pages)
- BioUniversal KFG (2 pages)
- Callisto 86 (2 pages)
- Harmony KF (2 pages)
- Callisto 86 (2 pages)
- Capricorn 15 (2 pages)
- BioUniversal KFG (2 pages)
- BioUniversal KFG (2 pages)
- BioUniversal E (2 pages)
- BioUniversal PdF (2 pages)
- Brite Gold (2 pages)
- Capricorn 15 (2 pages)
- Callisto Implant 33 (2 pages)
- Capricorn (2 pages)
- Colado CC (2 pages)
- Callisto 84 (2 pages)
- Callisto CP+ (2 pages)
- Callisto CPG (2 pages)
- Callisto Implant 60 (2 pages)
- CosmoPost (24 pages)
- Colado NC (2 pages)
- Elektra (2 pages)
- Evolution Lite (2 pages)
- ESPRIT (1 page)
- Elektra 10 (2 pages)
- IPS d.SIGN Ultra (2 pages)
- EP 5000 (1 page)
- Harmony 2 (2 pages)
- EP 600 (36 pages)
- Harmony Hard (2 pages)
- Harmony Medium (2 pages)
- Harmony Soft (2 pages)
- Heliobond (36 pages)
- Harmony 3 (2 pages)
- Harmony C&B 55 (2 pages)
- EP 600 Combi (40 pages)
- Harmony PF (2 pages)
- Harmony X-Hard (2 pages)
- IPS AcrylCAD (2 pages)
- IPS d.SIGN 30 (2 pages)
- IPS Classic (24 pages)
- IPS d.SIGN 59 (2 pages)
- IPS d.SIGN 84 (2 pages)
- IPS d.SIGN 96 (2 pages)