beautypg.com

Contouring the pontic – Ivoclar Vivadent Vectris User Manual

Page 50

background image

50

Contouring the pontic

First, seal the dies with a wax/stone or resin/stone separator. Contour the pontic on the master model in a cusp-supporting

manner similar to the metal-ceramic technique, using wax or composite (Light Tray). This step helps to obtain a

homogeneous layer thickness in the following veneering material. The occlusal abutment/pontic contact area in the cavity

should exhibit the following dimensions:

– cover the entire surface of the cavity

– length of the abutment/pontic area in the cavity: at least 4 mm

– thickness of the contact layer: at least 0.3 mm

– joint face of the connector: at least 3 x 3 mm

Check the pattern in the articulator and adjust as necessary. If a full wax-up has been prepared, the wax rims may be used

for checking purposes.

Contour the pontic on the master model.

Check the pattern in the articulator.

Conduct a final check of the duplicate model and check the dimensions of the pontic.

Tip:

The pontic can be contoured using a tray material (Light Tray) and adjusted by grinding after completion of the

polymerization process.

0.3 mm

3 mm

3 mm

4 mm

4 mm