Ivoclar Vivadent Telio CAD A16 User Manual
Page 17
17
Apply a thin layer of Multilink Hybrid Abutment HO 0 directly from the mixing tip to
the bonding surface of the Ti base.
Place the Telio CAD A16 structure on the Ti base in such a way that the position mark-
ings are aligned. Press the parts lightly and evenly together and check the correct rela-
tive position of the components (transition Ti base / Telio CAD structure).
Carefully remove excess in the screw channel, e.g. with a microbrush or brush, using
rotary movements.
Apply glycerine gel (e.g. Liquid Strip) to the cementation joint to prevent the
formation of an inhibition layer.
The composite cement auto-polymerizes within 7 min.
Important: Do not move the components until auto-polymerization is completed.
Hold them in place during this time.
Apply a thin layer of Multilink Hybrid Abutment HO 0 directly from the mixing tip to
the bonding surface of the Telio CAD structure.
Subsequently, tightly press the components together for 5 s.
Important: Do not remove circular excess cement before curing has started,
i.e. 2–3 minutes after mixing. Hold the components in place using light pressure.
5 s
2-3 min
7 min
Telio
®
CAD Abutment Solutions
– Cementation of Ti Base / T
elio CAD Structur
e