Cb/slider systems install track – Harken 3838 System B CB & Slider Battcars: built 2005-2006 User Manual
Page 7

7. Hold full-length track piece up to mast.
Loosely install top screw.
Use putty knife to slide additional slugs
and connector slug into place. Loosely
install all nineteen 6 x 20 mm screws.
8. Slide tracks up enough to fit next track.
Mast up: Hold upper tracks. Loosen screw
that holds tracks. Slide track up. If screws
bind in mast groove opening, loosen them
untill track slides. Tighten new bottom
screw securely.
WARNING! Do not let tracks drop. Severe
injury can result.
9. Repeat until full-length tracks installed.
10. Raise tracks so 9
1
/
2
" (241 mm) bottom
feeder track fits.
11. Install bottom feeder track with stop.
3850, 3851 Endstop Kit—leave
bottom 9
3
/
8
" (238 mm) track off
untill cars are installed.
CB/Slider Systems
Install Track
7
NOTE: If bottom full-length track blocks
feeder gap, load bottom track slugs before
installing track.
4252/1-05
System B (CB/Slider)
- 3839 System B CB & Slider Battcars: built 2005-2006 3840 System B CB & Slider Battcars: built 2005-2006 3841 System B CB & Slider Battcars: built 2005-2006 3842 System B CB & Slider Battcars: built 2005-2006 3843 System B CB & Slider Battcars: built 2005-2006 3833 System B CB & Slider Battcars: built 2005-2006 3836 System B CB & Slider Battcars: built 2005-2006 3834 System B CB & Slider Battcars: built 2005-2006 3835 System B CB & Slider Battcars: built 2005-2006 3845 System B CB & Slider Battcars: built 2005-2006 3846 System B CB & Slider Battcars: built 2005-2006 3847 System B CB & Slider Battcars: built 2005-2006 3848 System B CB & Slider Battcars: built 2005-2006 3844 System B CB & Slider Battcars: built 2005-2006 1616 System B CB & Slider Battcars: built 2005-2006