Harken 3838 System B CB & Slider Battcars: built 2005-2006 User Manual
Page 10

4. Attach head of sail to headboard
car with clevis pin and cotter pin.
2. Screw threaded stud to terminal.
3. Load toggle using 5 mm hex wrench
and 10 mm wrench or nut driver. Tighten
locknut. Do not over tighten.
1. Beginning with lower cars, use 5 mm
hex wrench and 10 mm wrench or nut
driver to attach sail to cars. Tighten
locknut until bottom tip of fastener is
flush with nut.
Do not over tighten. Make sure toggle
can pivot.
Slider System
Load Sail on Cars
CB System
Load Sail on Cars
Attach sail to system
beginning with lowest
car. Line up toggle and
insert clevis pin.
If it is a “no wind” day,
hoist mainsail as you
attach sail to cars.
10
System B (CB/Slider)
4252/1-05
This manual is related to the following products:
- 3839 System B CB & Slider Battcars: built 2005-2006 3840 System B CB & Slider Battcars: built 2005-2006 3841 System B CB & Slider Battcars: built 2005-2006 3842 System B CB & Slider Battcars: built 2005-2006 3843 System B CB & Slider Battcars: built 2005-2006 3833 System B CB & Slider Battcars: built 2005-2006 3836 System B CB & Slider Battcars: built 2005-2006 3834 System B CB & Slider Battcars: built 2005-2006 3835 System B CB & Slider Battcars: built 2005-2006 3845 System B CB & Slider Battcars: built 2005-2006 3846 System B CB & Slider Battcars: built 2005-2006 3847 System B CB & Slider Battcars: built 2005-2006 3848 System B CB & Slider Battcars: built 2005-2006 3844 System B CB & Slider Battcars: built 2005-2006 1616 System B CB & Slider Battcars: built 2005-2006