beautypg.com

Cb/slider systems install track – Harken 3838 System B CB & Slider Battcars: built 2005-2006 User Manual

Page 6

background image

1.

Slip top track slugs into mast groove. Use

1

7

/

16

" (36 mm) mounting slug for top stop.

Short top track lengths

Top slug

1

1

/

2

" (38 mm)

3" (76 mm)

2

3

/

8

" (60 mm)

7

/

8

" (22 mm)

Install 3" (76 mm) connector slug at

bottom.

Mast up: Tape 1

7

/

16

" (36 mm) slug even

with top of upper track. Tape other slugs

in place.

2. One drop blue Loctite

®

into each

connector slug hole.

3. Thread a 6 x 20 mm screw through

endstop, track, and into endstop slug.

Short top track lengths
1

1

/

2

" (38 mm)

Use one screw in stop

2

3

/

8

" (60 mm)

Use both screws

Mast up: Remove tape. Tighten screw to

hold track.

4. Slide slugs into place with putty knife.

Loosely install 6 x 20 mm screws.

TIP: Use putty knife to see if screws

are loose enough to slide in groove.

REMEMBER: Tracks may stick when

reaching a spliced area on mast.

5. Loosen top screw. Slide top track up and

position next 6'9

1

/

8

" (2.06 m) track.

Mast up: Tighten bottom screw to hold

track.

6. Slide 19 mounting slugs and connector

slug into mast groove.

Mast up: Tape in place.

Put one drop blue Loctite

®

into each hole.

CB/Slider Systems

Install Track

6

System B (CB/Slider)

4252/1-05