Grandstream GXV3611IR HD User Manual - Manual (Page 51)

Grandstream Networks, Inc. GXV3611IR_HD User Manual Page 51 of 64
Firmware Version 1.0.3.5 Last Updated: 11/2014
Alarm Event
This page allows user to configure the Alarm_In event and related actions.
Figure 25-1: Alarm_In Action Configuration Page
DI Alarm Action Setting:
 Pre/Post Alarm Recording (Record Video From Pre Alarm Up to XXX to After Up to XXX):
Depending on 1
st
stream resolution, this allows internal buffer to store the
pre/post alarm video for applications to utilize.
MJPEG is NOT supported for this feature.
 Voice Alarm to SIP Phone:
Enabled will allow device to make SIP call after receiving Alarm_In.
See below NOTE for example.
 Alarm Output:
Enabled will allow Alarm Output after receiving Alarm_In signal.
 Upload to Alarm Center: Upload to alarm center like 3 rd
party VMS system.
 Upload to Alarm HTTP Server:
Upload to 3 rd party HTTP server or application using HTTP API.
 Record Video and Upload to FTP Server:
Upload video recording to pre-configured FTP server.
 Email and FTP upload JPEG and Store it to SD drive:
Email, FTP and Store to the SD card the configurable trigger moment
JPEG snapshots.
Click “Save” to save the settings. Following bar will display if operation successful.
NOTE:
 Voice Alarm to SIP Phone: Application example: Intercom System, press button as Alarm_In, the
pre-programmed SIP number or peer IP device will be called. If the receiver is Grandstream Video
phone, the callee can use DTMF PIN code to operate and Open Door.