Grandstream GXV3611IR HD User Manual - Manual (Page 36)

Grandstream Networks, Inc. GXV3611IR_HD User Manual Page 36 of 64
Firmware Version 1.0.3.5 Last Updated: 11/2014
Networking Setting Page
This page allows user to configure network related parameters:
Figure 14: Networking Setting Page
 IP Address Configuration:
Camera IP address configuration
o Dynamically Assigned via DHCP: Default setting, DHCP server assign IP to camera.
o Statically Configured as: Static IP address configuration (Preferred for Port FWD)

DNS Configuration: DNS server IP. Must be configured if using static IP.

HTTP: Web access TCP port, default 80.
NOTE:
 If camera behind SOHO router with port forwarding configuration for remote access, static IP or
static DHCP has to be used to avoid IP address change after router reboot.
 TCP port above 5000 suggested if Port Forward HTTP for remote access, due to some ISP would
block port 80 for inbound traffic. For example, change the default HTTP port from 80 to 8088, to
make sure the TCP port not likely blocked.
 In addition to HTTP port, RTSP port is also required to configure via port forward, so remote
party can view the video stream.
 If revise the default TCP port 80 to port “A”, then RTSP port should be “2000+A” (changed from
default TCP 554). Both TCP port “A” and “2000+A” should be configured for port forwarding in
the router. For example, the HTTP port changed to 8088, the RTSP port now should be 10088,
both TCP ports 8088 and 10088 should be configured for port forwarding in order for remote
camera access: 8088 for web portal, 10088 for video streaming.