Gasboy EDS-CCIS Credit - Manual (Page 9)

Credit & Debit Card Networks EDS/CCIS 3
Gasboy CFN Series
Console (CONSOLE)
The Allow Hand Entry of Card Data parameter in the Console configuration program must be set to Yes.
Island card reader (READER)
Put the Select Pump step before the Verify Card step if you use $ AMOUNT for the Enter Amount prompt,
or if the fill limit of the pump is to be used to determine the authorization amount.
Special system setup
EDS/CCIS product names
Most card networks record the volume and dollar amounts of fuel purchased. EDS/CCIS also records the
type of fuel purchased. The first two characters of the product’s name are sent to EDS/CCIS as the product
code.
The product codes that EDS/CCIS recognizes are:
UR unleaded regular
UP unleaded premium
US unleaded super
LR leaded regular
LP leaded premium
M1 diesel #1, mini-serve
M2 diesel #2, mini-serve
F1 diesel #1, full-serve
F2 diesel #2, full-serve
S1 diesel #1, self-serve
S2 diesel #2, self-serve
Use the LOAD PRODUCT command to name the fuel products at your site. Name the products
according to the chart above. The first two characters of each name must be the appropriate two characters
shown in the first column. The LOAD PRODUCT command has a 12-character limit for product names, so
use the remaining 10 characters to further identify the product. For instance, a recommended name for self-
serve diesel #2 would be S2_Diesel.
Special operation for EDS/CCIS
Unlike other networks, EDS/CCIS does not have a formal settlement procedure once every 24 hours.
Instead, when your site dials EDS/CCIS to request a transaction authorization, information on the previous
completed EDS/CCIS transaction is transmitted at the same time. If there is a long time between EDS/CCIS
transactions, data on the previous transaction would not reach EDS/CCIS in a timely manner.
In order to be sure that transaction completions are set to EDS/CCIS on a timely basis, load a cron that
will be executed 15 minutes before each hour. This will cause pending completions to be sent to EDS/
CCIS. For example,
LOAD CRON 1 @45 -settle
This command does nothing if there are no pending completions.
The transaction pointer
If you are not regularly polling and resetting the transaction pointer, then you should run the PURGE SITE
command once a day so you do not fill up the Site Controller’s memory.