Gasboy CFN Islander I User Manual
Page 7
Page
7
1.
All wiring is to be installed and used in accordance with all building/fire codes, all Federal, State, and Local codes, National
Electrical Code (NFPA 70), NFPA 30, and Automotive and Marine Service Station Code (NFPA 30A) codes and regulations.
Wiring must also conform to the wiring diagram supplied with the pump/dispenser.
2.
All peripheral equipment connected to the RS-232 ports must be UL-Listed, have an Electronics Industry Association (EIA)
standard RS-232 communications protocol and not be installed over a hazardous location.
3.
The above wiring diagram illustrates a CFN System with every component to indicate how they are interconnected. Components
that are not a part of your system should be ignored.
4.
When using shielded cable for the RS-485 communication wiring, ground the shield to the AC ground used for the system
components (on one end only).
5.
CFN island card readers (ICR's) are interchangeable with satellite Islanders in your configuration.
6.
Consult the applicable section of the Installation Manual for specific system installation requirements.
7.
For Islander II connecting to Tokheim DPT’s, consult the Pump Interface manual or contact Gasboy Technical Service for special
instructions.