Gasboy ICR Power Supply Replacement - Manual (Page 2)

Rev. 4131 C35550
Use this drawing as a guide for Steps 6 through 8.
6. Attach the 6 conductor DC power cable of the new power supply to P4 of the CPU PCB. The orange wire
should be at the top and the violet wire should be at the bottom of the connector.
7. Install the new power supply to the main bracket assembly using the four nuts.
8. Attach the 2-conductor DC cable to the 2-position cable supplied with new power supply. Attach the AC cable
to the new power supply.
9. Turn the power switch on.
10. Measure the DC voltage and adjust if necessary, referring to Section 4 of the GASBOY CFN Diagnostic
Manual C01759.