Gasboy ICR Power Supply Replacement - Manual

C35550 Rev. 4131
INSTRUCTIONS FOR C06327 POWER SUPPLY REPLACEMENT KIT
This kit is used to update the CFN Island Card Reader from a C05403 to a C05801 power supply assembly.
Locate and identify the following parts in the power supply replacement kit:
QTY PART NO. DESCRIPTION
1 C05801 Power Supply Assy., ICR
1 C05026 Cable Assy., R/T DC Power (6 conductor cable attached to rear of C05801 supply)
1 C05936 Cable Assy., ICR DC Power I/F (2 conductor cable attached to front of C05801 supply)
1. Unlock the Island Card Reader (ICR) door. Remove the two door bolts using the tamper-proof socket
(C04479) shipped with the ICR. Open the door. Refer to the drawing below for Steps 2 through 5.
2. Turn off the main power switch located on the top left bracket assembly above the AC terminal block.
3. Pull off the DC cable from connector P4 (lower righthand corner) of the CPU PCB.
4. Pull off the DC (+5V DISPLAY) and AC (115 VAC) cables from the front panel of the old power supply.
5. Using a 5/16 socket, remove the four nuts securing the power supply to the main bracket assembly. Remove
the old power supply, pulling the 6-conductor DC cable with it. Discard the cable. (It is too short to be used
with the new supply).