Gasboy 9120 Pulser - Manual (Page 2)

032006 Rev. 9223 Page 2
8. Install lower half of gear train assembly, 022432, using
supplied screws and lock washers.
9. Install one brass washer (supplied with gear train
assembly) to gear train assembly.
10. Install gear (supplied with gear train
assembly) on top of brass washer.
11. Assemble one 042130 pin into 034709 link-
drive.
12. Install 034715 link-drive to gear from gear
train assembly with other 042130 pin.
13. Assemble existing bracket (from Step 6) to 022431 gear train top with
053000 screws and Z09273 nuts. NOTE: Remove grease and shavings
from cover of gear train.
14. Assemble gear train top to gear train bottom with four screws supplied.
15. Install 034709 brass link to pinned link-drive.
16. Re-install gear train cover set aside in Step 3, aligning pins from cover
with brass links on meter and register. Once in place, assemble using
existing hardware reserved from Steps 1 and 2.
Continued on the next page