Gasboy M08400 User Manual
Page 6
Installing the M08400A001 Kit
Atlas
™
is a trademark of Gasboy International. Gasboy
®
is a registered trademark of Gasboy International. Phillips
®
is a registered
trademark of The Phillips Screw Co.
© 2010 GASBOY
7300 West Friendly Avenue · Post Office Box 22087
Greensboro, North Carolina 27420
Phone 1-800-444-5529 ·
· Printed in the U.S.A.
MDE-4740B Atlas™ Bezel Upgrade Kit (M08400K001) Installation Instructions · February 2010
Figure 3: Bezel Sealing Gaskets
Note: Figure shows how the two top cover screws are used to mount the wiper
gasket (M08340B001).
Gasket 1/4 X 1/2 X 1
Gasket 1/4 X 1/2 X 25.7
Gasket 1/4 X 1/2 X 3.15
Seal, Bezel Top (M08340B001)
Screw, 12-24 (Silver Painted Head) (M04287B001)
Gasket, Upper Housing Side (M05095B001)
To install the kit, proceed as follows:
1
Remove the dispenser lower door using the key.
2
Remove the two Wing nut fasteners at the lower corners of the existing Atlas Bezel. Remove
the existing Bezel.
3
Remove the two Phillips head screws that secure the top cover (see
).
4
Place the wiper gasket (M08340B001) in the hanger trough (see
), and install the
screws that were removed in step
. The top cover and wiper gasket are now installed.
5
Place adhesive-backed gaskets (items 3, 4, and 5 in
on
) along the lower
edge (see
).
6
Position the new Atlas Bezel so that its hanger (see
) fits into the hanger
trough of the top cover.
7
Reinstall the two Wing nut fasteners at the lower corners of the Atlas Bezel. The bezel is now
fully installed.
8
Replace the dispenser lower door.
9
Repeat steps
for Side B of the unit.
The installation of the M08400A001 kit is complete.