Gasboy Atlas Single Std. Inlet Centering Kit - Manual (Page 6)

Installation of the Kit
Page 6 MDE-4637A Single Standard Pump/Dispenser Inlet Centering Kit (M07676K00X) Installation for Atlas™ Units · August 2007
Installing the M07676K002 Kit on a Self-contained Pump
To install the M07676K002 kit on a self-contained pump, proceed as follows:
1 Remove the three bolts and lock washers that attach the existing pump inlet adapter and
gasket. Discard the adapter, gasket, and hardware.
2 Lightly apply some grease to both discharge flanges of the inlet manifold (M05347B010).
3 Attach two gaskets (M06101B001) to the flanges in the mating position.
4 Lightly apply grease to the face of the existing pump inlet.
5 With the gasket in place, attach the manifold to the pump inlet and secure using three
lockwashers (M01071B001) and three socket head screws (M04973B005). Tighten the screws
to a snug fit; do not overtighten.
6 With the gasket in place on the manifold face opposite the pump, lightly grease the mating
face of the manifold blanking plate (M07675B001) and place it on top of the pump and motor
support plate.
Note: The manifold blanking plate is not symmetrical and will fit only one way when bolts are
attached.
7 Secure the manifold blanking plate to the manifold using three lockwashers (M01071B001)
and three socket head bolts (M04973B005). Tighten them to a snug fit; do not overtighten.
8 Secure the blanking plate to the underside of the pump and motor support plate using two
flanged screws (M00415B009) and tighten.
9 Tighten all the six screws that attach the manifold to the pump and blanking plate.
10 Check for leaks upon initial operation of the unit.