Setting the date and time, Initiating a page – GAI-Tronics 10959-101 Wall-Mount Audio Messenger Interface (AMI) User Manual
Page 21
Pub. 42004-398E
M
ODEL
10959-10
X
W
ALL
-M
OUNT
A
UDIO
M
ESSENGER
I
NTERFACE
P
AGE
19 of 31
f:\standard ioms - current release\42004 instr. manuals\42004-398e.doc
10/09
When power is applied to the AMI and the power up sequence begins, the LCD display begins cycling
through the following messages:
• AMI
x.x.x
(x.x.x
AMI
Main
board
firmware
version)
• Boot DSP
• CompactFlash
®
detected
(CompactFlash
®
card detected)
• EEPROM
xxx
(xxx
AMI
Main
board
EPROM
format)
• DSP VER:x.x.x
• Flash OK (Successfully read whole CompactFlash
®
card)
• Progress bar
CFG Loading
(Configuration loading)
• Configuration Version
• Configuration Date and Time
• Configuration
file
name
(i.e.,
AMI
factory
default)
• Time and Page Symbol (page symbol is a speaker)
HIO board firmware version
(if HIO controller board installed)
• Time and Page Symbol (page symbol is a speaker)
ASM board firmware version
(if ASM board installed)
• Time, Party Line and Page Symbol (default party line is 1, if Page/Party
®
board installed)
Page/Party
®
board firmware version
(if Page/Party
®
board installed)
• Time, Party Line and Page Symbol
AMI Main board firmware version
• ## Time, Party Line and Page Symbol
Telephone
Interface
Mode
(default
is
Page/Party
®
mode)
• Time, Party Line and Page Symbol
Telephone Interface Board firmware version
(if Telephone Interface Board installed)
• ## Time, Party Line and Page Symbol (default is no greeting)
Telephone Interface Greeting file name
(this prompt is not displayed.)
• Time, Party Line and Page Symbol
AMI
ready
(System
is
now
running,
displayed
for
two
seconds
only)
• Time, Party Line and Page Symbol
Date
(date
will
display
on
the
start
of
the
next
minute)
## Will only be displayed if a Telephone Interface board option is installed
Setting the Date and Time
To set the time and date, please refer to LCD Display and Push-button Operation on page 21.
Initiating a Page
Using one of the connected inputs or the AMI push buttons, initiate a page. After the page is initiated,
verify the proper message is played to the proper audio system (i.e., Page/Party
®
) and the proper output
combination is asserted. If using the AMI Factory Default configuration, a message and corresponding
output are assigned to each of the first seven inputs.