FSR FLEX CONTROL BUILDER TRAINING MANUAL - Manual (Page 95)

LIT1368E Flex Training Manual
Page | 95
32600 LIT1368F
library contains a single sample switch command that can be edited for the desired
parameters.
Another place that this comes in handy is with mixers and volume controls that have
discrete level commands. Again, it is impractical to place a command for every posssible
level in the library. Instead a sample command is in the library that can be edited with the
desired parameters.
For this example we will send a command to an FSR Intelli-Tools VCM. This is a serially
controlled volume control.
To Send an Inline Serial Message, follow these steps:
First select the IT-VCM from the serial control Library FSR Intelli Tools folder.
Now use the drop-down menu to select the serial port that the IT-VCM is connected to.
The Flex CU can automatically add a carriage return or a carriage return and line feed
to the end of the command that you enter. You should consult the manual of the
device that you are controlling to know if a or are needed.
Note: If you are going to edit a command from an existing serial library, the carriage return
or carriage return and line feed will already be in place and you should select No carriage
return.
Make the appropriate selection under Carriage Return Handling.