FSR FLEX CONTROL BUILDER TRAINING MANUAL - Manual (Page 78)

LIT1368E Flex Training Manual
Page | 78
32600 LIT1368F
For ease of explanation, we will setup a virtual button press and virtual button state to
power our system on and off from the TEST screen.
Select the B button. This will be a toggle button type so click on the toggle tab to enter
actions.
Now select virtual button press from the actions list.
Select the Home screen rom the list and then click on the System Power button on the
HOME screen displayed on the right.
Click OK
Now click into the actions box labeled High to Low and repeat the commands above to
perform a Power off now.
Virtual Button State
Now that the virtual button has been set, we want to show the state of the virtual button
pressed.
Click back into (Low to High) box and then click on Virtual button state command.
Now click on the HOME screen.
Click on the System Power button. By default, the Set State to 1 is selected as shown below.