Foxconn N68S7AA-8EKRS2H User Manual
Page 39
Chapter 3 BIOS Description
31
v
OnBoard Floppy Controller
This option allows BIOS to enable or disable floppy Controller.
v
Serial Port1/2 Address
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard serial port .
Note: Do not try to set the same values for serial ports 1 and 2.
v
IrDA Mode
This option allows BIOS to select mode for serial port 2.
v
IR Duplex Mode
This option allows BIOS to select full or half duplex for serial port 2.
v
IRTX Pin Select
This option allows BIOS to select transmit pin in normal condition or
inverse the IRTX.
v
IRRX Pin Select
This option allows BIOS to select receiver pin in normal condition or
inverse the IRRX.
v
IR Tx to Rx Delay Select
This option allows BIOS to select IR from Tx to Rx 4characters time delay for
serial port 2.
v
IR Rx to Tx Delay Select
This option allows BIOS to select IR from Rx to Tx 4 characters time delay for
serial port 2.
v
Parallel Port Address
This option is used to assign the base address for the onboard parallel port.
SuperIO Configuration Menu
PDF 文件使用 "pdfFactory" 试用版本创建