Foxconn N68S7AA-8EKRS2H - Manual (Page 23)

Chapter 2 Installation Instructions
15
Serial ATA II Connectors: SATA_1-2, SATA_3-4,
SATA_5-6
The Serial ATA II connector is used to connect the
Serial ATA II device to the motherboard. These
connectors support the thin Serial ATA II cables
for Serial ATA II devices. The current Serial ATA II
interface allows up to 300MB/s data transfer rate.
Chassis Intruder Connector: INTR
The connector connects to the chassis security
switch on the case. The system can detect the
chassis intrusion through the status of this
connector. If the connector has been closed once,
the system will send a message.
Audio Connectors: CD_IN
CD_IN is Sony standard CD audio connectors, it
can be connected to a CD-ROM drive through a
CD audio cable.
COM Connector: COM1
This motherboard provides an additional serial
COM header for your machine.Connect one side
of a switching cable to the header, then attach
the serial COM device to the other side of the
cable.
SATA_1/2/3/4/5/6
GND
GND
GND
RX+
RX-
TX+
TX-
1
INTR
INTRUDERJ GND
1
Speaker Connector:SPEAKER
The speaker connector is used to connect
speaker of the chassis.
SPEAKER
1
NC
SPKJ
SPKJ
Empty
CD_IN
1
CD_R GND CD_L
COM1
SOUT
GND RLSD RI
DTR
DSR SIN
9
10
1
2
CTS
RTS
Empty
PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn