Foxconn 915P7AD-8EKRS - Manual (Page 32)

Chapter 2 Installation Instructions
2 5
1394 Connector: F_1394 (optional)
The 1394 expansion cable can be connected to either the front (provided that
the front panel of your chassis is equipped with the appropriate interface) or
rear panel of the chassis.
Wake-Up On Internal Modem: WOM
Through this function, the system which is in supspend or soft-off status can be
waken up by a ring signal received from the internal modem. W hen this function
is enabled, make sure an internal modem card which supports this function is
used. Connect the header to the relevant connector on the modem card, set
“Power On by Ring” as “Enabled” in the “Power Management Setup” of the
CMOS Setup Utility. Save and exit, then boot the operating system once to make
sure this function takes effect.
+5V _SB
GND
WOM
1
Modem wake up
+12V
GND
TPB -
GND
TPA -
F_1394
1 2
9 10
+12V
TPB +
GND
Empty
TPA +
PDF created with pdfFactory Pro trial version www.pdffactory.com