Foxconn 915P7AD-8EKRS - Manual (Page 19)

Chapter 2 Installation Instructions
1 2
Memory
This motherboard accomodates two 184-pin(DDR) & two 240-pin (DDR2) slots.
DIMM1 and DIMM3 slots support 256 Mb, 512 Mb and 1 Gb DDR2 technologies
for x8 and x16 devices; DIMM2 and DIMM4 slots support 256 Mb, 512 Mb and
1 Gb DDR technologies for x8 and x16 devices.
DIMM1
DIMM2
DIMM3
DIMM4
Type I/O Voltage DIMM#
DIMM1/3
DIMM2/4
DDR2
DD R
1.8V
2.6V
Attention:
Memory Configuration Table (Use any of the recommended configurations in
the following table)
1. Before you install memory modules, please make sure that all
DIMMs in one system are of the same type (e.g. all DDR or all
DDR2, not mixed).
2. If DDR and DDR2 memory banks are installed simultaneously or
or all four sockets are populated with DIMMs, the buzzer will alarm
for memory error warning and power-on failure may result. But
in this case, it can not cause any damage to your motherboard
and memory banks since an exclusive protection circuit is spe-
cially designed for it.
DIMM1 DIMM2 DIMM3 DIMM4
x Populated x x
x x x Populated
Populated x x x
x x Populated x
x Populated x Populated
Populated x Populated x
Channel Mode
Single-
Channel
Dual-Channel
DIMM DDR
Type
D D R
DDR2
D D R
DDR2
PDF created with pdfFactory Pro trial version www.pdffactory.com