Foxconn Inferno Katana - Manual (Page 85)

5
78
5-2 BIOS Configuration
1. Enter the BIOS setup by pressing key during the POST(Power On Self Test).
2. Select the “Advanced BIOS Featu
res” from the “Main menu”, then select the “ IDE
Configuration ” item and press to go to the configuration items.
3. Select and Set the “Configure SATA as” option to [RAID].
4. Press to save the setting then PC will reboot itself.
5-3 Create RAID in bIoS
enter RAID bIoS Setup
When BIOS is restarted, it will display a message asking you to press + keys
simultaneously to enter the main menu of Intel
® Matrix Storage Manager Option ROM
Utility. Press the + to enter Configuration Utility.
Intel(R) Matrix Storage Manager option ROM v5.0.0.1011 ICH9R wRAID5
Copyright(C) 2003-04 Intel Corporation All Rights Reserved.
1. Create RAID Volume 3. Reset Disks to Non-RAID
2. Delete RAID Volume 4. Recovery Volume Options
5. Exit
RAID Volume :
None Defined.
Physical Disks:
Port Drive Model Serial # Size Type/Status(Vol ID)
0 Maxtor STM332082 6QF4CRAW 298.0GB Non-RAID Disk
2 WDC WD1500ADFD-0 WD-WMAP42036047 139.7GB Non-RAID Disk
3 WDC WD800AAJS-00 WD-WMAP95242993 74.5GB Non-RAID Disk
4 WDC WD3200AAKS-0 WD-WCARW4154961 298.0GB Non-RAID Disk
[↑↓]-Select [ESC]-Exit [ENTER]-Select Menu
Intel(R) Matrix Storage Manager option ROM v8.9.0.1023 PCH-D wRAID5
Copyright(C) 2003-09 Intel Corporation. All Rights Reserved.
[ DISK/VOLUME INFORMATION ]
[ MAIN MENU ]
1. Create RAID Volume
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
IDE Configuration
IDE Configuration Help Item
Configure SATA as
SATA#1 IDE Configuration Compatible
SATA#2 IDE Configuration Enhanced IDE
RAID
► Primary IDE Master Not Detected AHCI
► Primary IDE Slave Not Detected Disabled
► Secondary IDE Master Not Detected
► Secondary IDE Slave Not Detected
► Third IDE Master Not Detected
► Fourth IDE Master Not Detected
Hard Disk Write Protect Disabled
IDE Detect Time Out 35
ATA(PI) 80Pin Cable Detect Host & Device
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
Options RAID