Foxconn Inferno Katana - Manual (Page 55)

3
48
ALL Voltage Control
► CPU VCore Mode
This item is used to select the voltage mode for CPU VCore. Default Value is: [Dynamic Mode]. In
fact, dynamic mode means EIST Mode is enabled and the voltage is fixed.
► CPU Target Core Voltage
This item shows the CPU target core voltage.
► CPU VTT (UnCore) Voltage
This item is used to set CPU VTT Voltage. The maximum voltage available for adjustment is
1260mV, one step is 20mV.
Warning: Adjusting the voltage beyond the CPU VTT default voltage could result in damage to
the CPU.
► CPU VCore PWM VDroop
This item is enable or disable the CPU Vcore Power Mangement Vdroop.
Warning: Adjusting this item to [Enabled] could result in damage to the board.
► CPU Fuzzy Equalizer Control
This item is enable or disable the CPU Fuzzy Equalizer control. Enable this function, Fuzzy
Equalizer will control the CPU power phase.
► 1.8V PLL Voltage Setting
This item is used to set CPU PLL (Phase lock loop) Voltage. The default voltage is 1.8V.
Warning: Adjusting the voltage beyond the default voltage could result in damage to the
board.
► P55 PCH Core Voltage
This item is used to set P55 PCH Core Voltage. The default value is: [1.05V].
Warning: Adjusting the voltage beyond the PCH default core voltage could result in damage to
the PCH core.
► DRAM Voltage Setting
The maximum voltage available for adjustment is 2.86V.
Warning: Adjusting the voltage beyond the memories default voltage could result in damage to
the memory controller, the default voltage is 1.60V
► DIMM1,2 Vref C-Addr
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
ALL Voltage Control
******* CPU Voltages ******* Help Item
CPU VCore Mode
CPU Target Core Voltage Default
CPU VTT (UnCore) Voltage 1.10V
CPU VCore PWM VDroop Enabled Dynamic mode
CPU Fuzzy Equalizer Control Disabled Fixed Mode
******* Chipset Voltages*******
1.8V PLL Voltage Setting 1.80V
P55 PCH Core Voltage 1.05V
******* Memory Voltages*******
DRAM Voltage Setting 1.60V
DIMM1,2 Vref C-Addr 0.80V
DIMM3,4 Vref C-Addr 0.80V
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
Dynamic Mode
Options