Foxconn Destroyer User Manual
Page 50
43
3
rameters, so that the motherboard memory controller (chipset) can better access the memory.
This item can be valid only when the “Over Clock Phase Select” is set to [Manual O.C.].
The following items can be valid only when the “DRAM Timing Selectable” is set to [Manual].
► 1T/2T Memory Timing
This item is used for memory timing. 1T/2T timing setup is a memory optimizing technology, it
can improve the memory performance by reducing the read delay of memory controller.
► CAS# Latency Time (tCL)
The number of memory clocks it takes a DRAM to return data after the read CAS_L is asserted
depends on the memory clock frequency. The value that BIOS programs into the memory con-
troller is a function of the target clock frequency. The target clock frequency is determined from
the supported CAS latencies at given clock frequencies of each DIMM.
► RAS to CAS Delay (tRCD)
This item allows you to select a delay time (in clock cycles) between the CAS and RAS strobe
signals.
► Row Precharge Time (tRP)
This item allows you to select the DRAM RAS precharge time (in clock cycles).
► Min RAS Active Time (tRAS)
This item allows you to set the minimum RAS# active time (in clock cycles).
► Write Recovery Time (tWR)
This item allows you to select the write recovery time (in clock cycles).
► Write to Read Delay (tWTR)
This item allows you to select a delay time (in clock cycles) between sending the last data from
a write operation to the memory and issuing a read command.
► RAS to RAS Delay (tRRD)
This item allows you to select a delay time (in clock cycles) between the RAS and RAS strobe
signals.
► Read to Precharge (tRTP)
Internal READ Command to PRECHARGE Command delay (in clock cycles).
► Row Cycle Time (tRC)
This item allows you to set the row cycle time (in clock cycles). tRC = tRAS + tRP.
► Trfc0/1/2/3 for DIMM0/1/2/3
Refresh to Refresh or Refresh to Active command interval.
Trfc0: auto-refresh row cycle time for logical DIMM 0.
Trfc1: auto-refresh row cycle time for logical DIMM 1.
Trfc2: auto-refresh row cycle time for logical DIMM 2.
Trfc3: auto-refresh row cycle time for logical DIMM 3.