Quantum bios – Foxconn Destroyer User Manual
Page 46
39
3
Quantum BIOS
► CPU Feature / Memory Timing Setting / All Voltage Control / OC Gear
Press [Enter] to get into each submenu.
► Over clock Phase Select
It allows you to select the over clock phase. Setting value: [O.C. Disabled]; [Manual O.C.]; [In-
stant O.C.].
***Ratio and Clock Setting***
All the usable items can be valid only when the “Over Clock Phase Select” is set to [Manual O.C.].
► CPU Clock Ratio
This item is used to set the Ratio of CPU. Using different CPU, the setting values are different.
► CPU Frequency
This item allows you to adjust the CPU clock.
► Target CPU Core Speed
This item shows the target CPU Core speed.
► CPU And NB HT Speed
HT stands for HyperTransport bus. The CPU<->NB HT Speed option controls the physical
speed of the CPU to Northbridge HT link. The settings are [Auto], [1x], [2x], [3x], [4x] and [5x].
► Memory Speed Value
This item is used to set the memory speed value. The settings are [Auto]; [DDR 400]; [DDR 533];
[DDR 667]; [DDR 800]; [DDR 1066].
► System Memory Speed
This item shows the system memory speed.
► PCIE Clock
This item allows you to adjust the PCI Express bus clock.
*******Miscellaneous*******
► Auto Detect PCI Clk
This option is used to auto detect PCI slots. When enabled, the system will turn off clock of the
empty PCI slot to reduce EMI (Electromagnetic Interference).
► CPU Spread Spectrum
Phoenix - AwardBIOS CMOS Setup Utility
Quantum BIOS
► CPU Feature
[Press Enter]
Item Help
► Memory Timing Setting
[Press Enter]
► All Voltage Control
[Press Enter]
Menu Level ►
► OC Gear
[Press Enter]
Over Clock Phase Select
[O.C. Disabled]
****Ratio and Clock Setting****
x
CPU Clock Ratio
Auto
x
CPU Frequency
200
Target CPU Core Speed
2000MHz
x
CPU And NB HT Speed
Auto
x
Memory Speed Value
Auto
System Memory Speed
400MHz
x
PCIE Clock
100
*******Miscellaneous*******
Auto Detect PCI CIK
[Enabled]
CPU Spread Spectrum
[Disabled]
PCI Spread Spectrum
[Disabled]
iGPU Spread Spectrum
[Disabled]
Dual BIOS Select
[SPI 1]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
Press Enter